NOTE If the adapter pops off prematurely and the glue sticks to the dent you need to scuff the adapter for better adhesion and the glue sticks to the adapter you need to clean the surface of the dent again with WSol Cleaner Art No 8901138901130 for better adhesion NOTE If there is a soft filler life of putty or filler under the paint the adapter will pull off the paint as the adhesion of the filler is not strong enough to pull the dent CE RD PHG 250 0405 Copyright 2005 by Wurth 14 0212 1 Clean the dent with WSol Cleaner Art No 8901138901130 2 Fit the suitable adapter onto the extension lifter and apply glue to the middle of the adapter New adapters need to be scuffed for better adhe sion 3 Glue adapter to the deepest point of the dent if possible cool with pressurized air This way you should be able to pull the dent after approximately 30 40 seconds 4 Attach sliding hammer to the adapter and pull the dent 5 Heat the adapter with a hot air fan to a temperature of 150 C 302 F and with the help of the extension lifter re move the adapter in a side ways motion 6 Remove glue remnants with WSol Cleaner Art No 8901138901130 If needed heat the remaining glue and scrape off with a spreader 7 Finished product Application