In the pharmaceutical industry where vials are filled with tablets in a highspeed application as soon as each vial is filled a stopper must be properly inserted into the vial To ensure that a stopper is properly inserted as each vial leaves the filling station an iVu Series sensorset up for an Area application and motion parameters enabledverifies that the vial has a stopper inserted into its neck and that the stopper is positioned correctly to provide a proper seal on the glass vial If the stopper is missing or incorrectly positioned then the sensor sends a fail output to the line 22 Installing the Sensor 221 Mounting the Sensor The iVu Series sensor requires a bracket for mounting Four brackets are available from Banner The brackets allow the sensor to be mounted either perpendicular to the part or at an angle Available iVu Brackets SMBIVURAL SMBIVURAR SMBIVUU Mount the sensor securely using one of the brackets above and the three M4 x 4 mm screws that are supplied with the bracket Installing Filters on the iVu Series Sensor To install a filter on the iVu Series sensor use the illustration as a guide and follow the steps listed below NOTE Failure to follow these instructions can cause damage to your iVu Series sensor A Lens B Focusing Window C Locking Clip D Locking Screw iVu Plus Users Manual 8 wwwbannerengineeringcom tel 7635443164 Online Only rev A