2 Move the slider at the bottom of the screen to the to the desired Edge Length Range You can zoom in to refine the range Set the Pass Count parameter The sensor aggregates all the edge pixels that fall within the Edge Length Range and indicates the value with a small colored bar at the bottom of the page If within the range brackets the bar is green otherwise it is yellow 1 Go to Main Menu Inspection and click the Pass Count option 2 Use the brackets to set a tolerance for the passfail 4 Test the complete range of good and bad samples to make sure that the sensor accepts good parts and rejects bad 5 To complete the Blemish application setup set triggering as appropriate for your application NOTE Remote Teach does not work with the Blemish Sensor type 45 Configuring a Match Sensor This section describes how to configure a Match sensor using the Demo application as a reference iVu Plus Users Manual Online Only rev A wwwbannerengineeringcom tel 7635443164 57