BRELK O CONVEYOR PRODUCTS P O Box 62392 Marshalltown 2107 T el 27 01 1 0134000 Fax 27 01 1 0134150 email infobrelkocom W eb www brelkocom All technica l and dimensional information subject to change All general T erms and Conditions of sale including limitations of our liability apply to all products and ser vices sold V ersion 63 062013 INST ALLA TION GUIDE REF DR W No BT A 024 1 If not assembled refer to assembly instructions and DR W No BT A 023 Check that all necessar y parts have been supplied for belt width troughing angle and number of rolls ordered 2 Remove existing idlers and rolls from conveyor structure in the area where the system is to be installed 3 If assembled remove garland idler strings and the support beam 1 with uprights 5 4 Check direction of belt travel and slide unit under conveyor belt from one side Note F or lar ger sizes lif ting equipment may be required 5 P osition unit in impact zone and align centrally to belt 6 Attach support beam 1 with uprights 5 to transoms 10 7 Attach garland strings to BT A mounts 2 with M16 bolts supplied Securely fasten bolts and nuts 8 Attach retaining chains 9 using chain links 8 with nyloc nuts 9 Chain 9 connected to T link 7 which is bolted to transoms 10 Note Belt direction 10 Check centre roll height the belt should just be in contact If necessar y add spacers under the transom ends Or if the unit needs to be lowered notch the transom ends and reweld hold down plates 11 Securely fasten system to conveyor stringers 12 Check that garland strings do not catch on transoms and that there is freedom of movement of the garland strings in a vertical direction 13 Check chute sealing to the conveyor belt preferably fit BRELK O KEYSKIRT to contain any spillage Note Standard units are for installation in a horizontal position only F or inclines etc refer to the Brelko Design Dept